11
Section 7: Basic Operation
When connecting or disconnecting any cables, remove the port cover rst.
Refer to Section 6.1.
1. Insert one end of the HDMI cable into your PC’s graphics card. A VGA cable
may also be used. A VGA cable is not included.
2. Connect the other end of the cable to the corresponding connector on your
monitor.
VGA Connector
HDMI Connector
3. Connect the power cable to your monitor then connect the other end to your
power source. It is recommended that you use a surge protector with adequate
voltage if a wall outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
FreeSync
Please note: FreeSync is turned off by default. To enjoy the benets of FreeSync,
you must have hardware with FreeSync capability, an HDMI cable, and the latest
graphic drivers. To use this feature, connect your computer and monitor with an
HDMI cable. After connecting, you may receive a prompt to enable the feature on
your computer. If you do not receive the prompt, you can enable the function in your
graphics card menu. See your graphics card manufacturer’s documentation for
instructions on how to turn on and/or enable FreeSync.
Section 8: Indicator Light
Indicator Light
Solid blue light indicates power is on and the monitor is operating normally. Flashing
blue light indicates no video source has been detected. Red light indicates that no
horizontal or vertical signal has been detected or voltage is low. Please ensure your
computer is on and all video cables are fully inserted and/or connected.
To Next Page
Loading...
Need help?
General
