8
Section 5: Mount Installation
This monitor ONLY includes screws that may be used when attaching the
monitor to a VESA 75 x 75mm type mount. No VESA mount or mounting
accessory is included.
Keep the foam underneath the monitor before attaching the stand to a mount
or accessory.
1. Open the package and take out the monitor with foam still attached. Gently place
it on a desktop or table. Remove the extra parts and the foam covering the back
of the monitor. Press the release button to remove the stand plate. If the monitor
is already attached to the stand, remove the stand.
Release Button
Stand Plate
2. Remove the original screws x 4 (
1
) from the opening in the back of the monitor.
3. Follow the directions received with your VESA mount, stand, or accessory and
install the monitor on the wall or xture as desired. Remember to use the included
NO. 2 screws when mounting the monitor. Refer to the image (
2
) for correct
screw placement.
1
Use the 31mm
NO. 2 Screws x 2
Use the 26mm
NO. 2 Screws x 2
2
- Use only the NO. 2 Screws (31 mm x 2 pcs, 26mm x 2 pcs) provided
for this type of installation.
- Do not discard the original screws. These may be needed for future
use.
Mount
(Not included)
To Next Page
Loading...
Need help?
General
