Vision 16 Series User Manual

Maintenance 25
© 2013 Vision Engraving & Routing Systems
What not to Lubricate
Many of the bearings and assemblies in your engraving machine are sealed and/or coated using
special low-friction methods and should not be lubricated. Do not not attempt to lubricate the spindle
bearings. If you suspect lubrication problems, call Vision for instructions, as further lubrication may
harm the machine. Do not not lubricate the X or Y stepper motors.
Maintenance Schedule
The following is a suggested maintenance schedule. Remember that in conditions of prolonged use,
unusual environments, or unusual applications, maintenance items may need to be performed more
frequently than suggested in this schedule.
Frequency
Maintenance Items
As Needed
Vacuum and/or brush debris
Clean Vacuum Canister Filters (if equipped with Vacuum Chip Removal
System)
Every Day
Remove chips from the spindle area
Every Week
Clean and Lubricate X and Z-Axis Linear Rails
Every Month
Lubricate X, Y and Z-Axis Leadscrews
Lubricate the Spindle Housing
Every Year
Lubricate Y-Axis Linear Rails

Vision 16 Series Specifications

General

Brand	Vision
Model	16 Series
Category	Engraver
Language	English