Equipment
Description
Equipment Description
- 10 -
Figure 1
3.1 Pumping Equipment
1. Discharge Flange
2. Pump Lifting Eyebolt
3. Oil Filling and Aeration Plug
4. Bearing Body
5. Tap Protector
6. Motor Lifting Eyebolt
7. Electric Motor
5
3.2 Identification Plate
The operation of a centrifugal pump, chosen in accordance with all the technical background, can give poor service for various
reasons. This is generally due to improper installation or mishandling of the pumping equipment.
Efficient service can only be achieved by installing the pump correctly, therefore, the instructions in this manual must be
complied with in their entirety. Pumps should not be used for purposes other than the service conditions stipulated at the time
of purchase. The nameplate installed on the pump describes the most important features of the equipment purchased:
1. Serial Number
2. Flow rate (m3/h)
3. Metallurgy Material and S. M. Spring
4. Sealing Type
5. Impeller Ø
6. Face Mat., S. M. Elastomers and Pump Orings
7. Type of Lubrication
8. Bearing Body Type and Shaft Mat.
9. Wet End Pump Mat.
10. Pump Model
11. Pump Series
12. Head (mca)
13. Speed (rpm)
14. Year of manufacture
Figure 2
8.- Lifting Eyebolt of Pumping Equipment
9.- Motor Terminal Box
10.- Pumping Equipment Base
11.- Coupling Tap
12.- Bearing Body Support Foot
13.- Oil Level Maintainer
14.- Union Body
15.- Pump Body Leg
16.- Pump Body
17.- Suction Flange
18.- Priming plug
19.- Pressure gauge plug
20.- Plug for Vacuum Gauge
21.- Drain plug
To Next Page
Loading...
Need help?
General
