Defrosting
windscreen and side
windows
• Move all levers fully to the right.
• Switch blower to stage 2 with
switch E.
• Switch off blower of additional heat
exchanger*.
Demisting
windscreen and side
windows
When
the windows mist up due to high
air
humidity, e.g. when it is raining, we
recommend
the following settings:
• Move levers A, C and D fully to the
right.
• Move lever B slightly to the right into
the heating range, if necessary.
• Blower switch E to stage 2 or 3.
•
Close
vents 3.
Heating
interior
as quickly as
possible
• Levers A, B + D fully to the right
• Lever C fully to the
left
•
Close
vents 3
• Switch blower to stage 2 with
switch E.
Heating
interior
normally
When
the windows are clear and the
desired
temperature has been reached,
we recommend the following settings:
• Lever A to the
left
• Lever B to the desired heat output
• Lever C to the
left
• Blower switch E at stage 1
Ventilation
When
heating is off, fresh air flows from
all
vents. When heating is on, only from
vents 3.
Notes
• In order to ensure that the heating
and
ventilation works properly, the blow-
er
should always be switched on when
driving slowly.
• To prevent contaminated air from
getting into the vehicle, move lever A
fully to
left
and levers C and D fully to
right. The vents 3 must also be
closed.
• The heat depends on the engine tem-
perature - the full heat output is there-
fore only available when engine is warm.
• All controls except blower switch E
can
be set to any intermediate position.
• Depending on vehicle model the
stale
air can escape either through slots
in the
front
doors or through slots in the
rear
side windows.
The
slots in the
front
doors can be
opened
or closed by means of
slides.
45
To Next Page
Loading...
Need help?
General
