OPERATING
INSTRUCTIONS
Diesel engines
A
special very high quality oil is put in the
engine at the factory and this can be used
all
the year round - except in very cold
cli-
mates.
For
topping up and changing, the follow-
ing mineral or synthetic oils are to be
used:
• Good quality oils, specification API-
CD
(only for topping up on the Turbo
Diesel
engines in an emergency) or
• Multigrade oils, specification VW50101
(not for Turbo Diesel engines) or
• Multigrade oils, specification VW
50500
or
• Improved libricity oils, specification VW
50000
(not for Turbo Diesel engines) or
• High performance engine oils, specifi-
cation VW 50000 and 50500.
The
specifications must be marked on the
container. When topping-up the oils can
be
mixed
with
one another.
The
advantages of improved lubricity and
high performance engine oils for petrol
engines
mentioned on the previous page
also
apply when these oils are used in
Diesel
engines.
C
°F
40
100
80
60
40
20
0
20
o o
]
J
3
I
< <
< <
II
SAr i
u
A
- High performance and Improved lu-
bricity oils, B - Multigrade oils, C - Single
grade oils.
The
viscosity class of the oil must be
selected
as shown in the Fig. The oil
does
not have to be changed when the
ambient temperature is briefly above the
range shown.
When
using SAE 10 W single grade oil do
not drive
with
high engine speeds and
full
throttle
for long periods.
Manual
gearbox
and
final
drive
•
Gear
oil,
API-GL
4, SAE 80
Front
axle
differential
(syncro)
•
Gear
oil,
API-GL
5, SAE 90
Automatic
gearbox
• Final drive:
Gear
oil,
API-GL
5, SAE 90
• Gearbox part: ATF Dexron®
Power
assisted
steering
• ATF Dexron®
Lubricant
additives
No
additives
should be
mixed
with
the
engine
oil or the
other
lubricants.
Any
damage
caused by the use of such
additives
will
not be covered by the
war-
ranty.
73
To Next Page
Loading...
Need help?
General
