In particular, the operating company has to
ensure that:
• The load handling device is only used
as intended.
• The load handling device is only used
in proper, functioning condition and,
inparticular, the functionality of the
safety devices is checked regularly.
• The required protective equipment for
the operating, maintenance, and repair
personnel is on hand and used.
• The operating manual, complete and in
legible condition, is always available at
the location where the load handling
device is used.
• The load handling device is only
operated, maintained, and repaired by
qualied and authorized personnel.
• This personnel is instructed regularly in
all relevant aspects of occupational
health and safety and environmental
protection, and is familiar with the
operating manual and in particular
thesafety instructions it contains.
• All safety notices and warnings on the
load handling device remain in legible
condition and are not removed.
2 | Safety notices
Making structural changes to the load handling device is prohibited.
DANGER
• In case of damage, the load handling
device may only be used again after it
has been repaired by a qualied
person. Only original replacement
parts may be used.
• Failing to comply with these provisions
voids all warranty claims.
• The manufacturer assumes no liability
in case of unauthorized conversion of
the components.
• The allowable ambient temperature
for storage and operation is -20°C
to+60°C.
• Using the device in potentially explosive
atmospheres is not permitted.
Proper use
• The load handling device is intended
for lifting and transporting loads.
• Complying with the manufacturer’s
instructions for operation,
maintenance, and upkeep as well as
repair guides is mandatory for
properuse.
• Exceeding the specied limit values is
not permitted.
Safe operation is not assured if the load handling device is not used as intended.
Allcases of personal injury and damage to property caused by improper use are
thesole responsibility of the operating company.
NOTICE