96
311. Tighten the oil cooler to the engine. Tool width:
29 mm.
312. Connect the wire to the oil pressure sender.
Tool width: 3/8". Then pull over the protective rubber
cap (1). Also clamp the wire to the cooling water
pipe (2).
313. Oil the gasket of the oil filter and install the fil-
ter by hand until the rubber gasket touches the en-
gine block. Then turn the filter by hand a further 1/2
turn. Check the oil pressure and also for leakages
around the oil filter during the first test run.
To Next Page
Loading...
Need help?
General
