93
5C Installing the external
components
The distributor 230, 250, AQ131–151
295. Turn the crankshaft to the firing position for
number 1 cylinder. Check to make sure that the
camshaft cams for number 1 cylinder are pointing
away from each other and that the pulley marking is
indicating ‘0’.
296. Put on a new gasket and install the valve cover
and the plate for the belt marking. Make sure that
the belt marking coincides with the recess of the
plate. Adjust if necessary.
297. Remove the distributor cap.
298. Turn the rotor so that the marking on the rotor
is pointing approx. 60° away from the marking in the
distributor.
299. Push the distributor down into its location in the
engine block and make sure that the rotor lines up
with the marking in the distributor housing. Tighten
the distributor in this position.
300. Install the distributor cap.
To Next Page
Loading...
Need help?
General
