EasyManuals Logo
Home>Volvo Penta>Engine>D1 Series

Volvo Penta D1 Series User Manual

Volvo Penta D1 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Fuel system, bleeding
The fuel system must be purged after a filter change,
if the fuel tank has been run dry and after a long-term
stoppage.
1 Open the purge screw (1) on the fuel filter console
approx. three turns. Avoid fuel spills; use rags to
soak up fuel at the purging point.
2 Pump fuel up with the hand pump (2) until fuel
without air bubbles can be seen. Continue pumping
and tighten the purging screw at the same time.
3 Start the engine and check for leaks.
Fuel pre-filter
The fuel pre-filter is an optional extra.
Draining
Wait a few hours after the engine has been turned off
before draining the filter.
Position a container under the fuel filter. Drain off water
and contaminants using the cock/plug at the bottom of
the filter bowl.
Replacing filter insert
1 Close fuel cock at the fuel tank. Position a
containerunder the fuel filter.
2 Remove the filter bowl by undoing screw (1).
3 Empty and clean the filter bowl. Replace insert and
reinstall the bowl.
4 Open fuel cock.
5 Vent the fuel system, please refer to section Fuel
system, bleeding, page 57.
6 Start the engine and check for leaks.
7 Deposit the old filter insert at a properly designated
disposal site.
Maintenance
47711262 01-2019 © AB VOLVO PENTA 57

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volvo Penta D1 Series and is the answer not in the manual?

Volvo Penta D1 Series Specifications

General IconGeneral
BrandVolvo Penta
ModelD1 Series
CategoryEngine
LanguageEnglish

Related product manuals