52
Maintenance schedule
cont. Every 200 hours / at least once a year:
● Engine oil. Change
1)
.......................................................................................page 57
● Oil filter. Change
2)
.........................................................................................page 56
● Air filter. Change ............................................................................................page 54
● Exhaust line. Checking .................................................................................. page 54
● Sea water pump. Checking of impeller ...........................................................page 61
● Fuel filter/ fuel pre-filter. Change ............................................................... page 64-65
Clean and touch up the paintwork as necessary ........................................ not shown
Check the condition of all rubber hoses, and re-tighten the hose clamps ... not shown
Outboard drive. Changing the universal joint bellows .................................. not shown
Every second year:
● Coolant. Change ............................................................................................page 60
Every 600 hours / at least every 5 years:
Reverse gear. Changing the propeller seal ................................................. not shown
Turbo. Inspection/cleaning as necessary ................................................... not shown
Trim/steering cylinders, hoses, hydraulic hoses. Leakage check ............... not shown
Outboard drive, check for function and wear .............................................. not shown
– Bushes/shaft stubs in shield and suspension fork.
– Propeller shaft seal
– Propeller shaft, checking straightness
– Gear change mechanism and control cable
– Steering
Every 1200 hours / at least every 5 years:
Heat exchanger. Inspection/Cleaning ......................................................... not shown
Intercooler. Inspection/Cleaning ................................................................. not shown
Control cables and seals. Change .............................................................. not shown
Coolant pipes. Inspection ........................................................................... not shown
– Checking hoses, unions and hose clamps
Safety and function check ........................................................................ not shown
– In a safety and function check, the outboard drive is disassembled to check for wear and
damage. Any faults are rectified. If necessary, the complete drive is changed.
Every 1400 hours:
Camshaft belt. Change .............................................................................. not shown
1)
Oil change intervals vary, depending on oil grade and sulfur content of the fuel. Please refer to
"Maintenance: Lubrication system".
2)
Change the filter at each oil change.
To Next Page
Loading...
Need help?
General
