51
Maintenance schedule
Your Volvo Penta engine and its equipment are designed for high reliability and long service life. They are built to
withstand the marine environment, and to minimise their impact on it. Given regular maintenance, as in the sche-
dule, these properties will be maintained and unnecessary malfunctions will be avoided.
Warranty inspection
During the first period of use, the specified warranty inspection, “First service inspection”, must be done at an
authorised Volvo Penta workshop. Instructions about when and how this must be done are found in the Warranty
and Service Book.
MAINTENANCE SCHEDULE
WARNING! Before you do any maintenance work, read the “Maintenance” chapter care-
fully. This contains advice on doing the work in a safe and correct manner.
IMPORTANT! Maintenance points marked must be done by an authorised Volvo Pen-
ta workshop.
Daily, before first start:
● Engine and engine room. General inspection..................................................page 53
● Engine oil. Checking the level ........................................................................page 56
● Coolant. Checking the level ........................................................................... page 61
General inspection of drive, propeller, shield. Leakage and function check. not shown
Every 14 days:
● Battery. Checking of the electrolyte level .......................................................page 67
● Seawater filter. Cleaning ................................................................................page 63
● SX and DP-S drives. Checking sacrificial anodes ..........................................page 73
● XDP drives. Checking sacrificial anodes ........................................................page 79
● SX and DP-S drives. Checking of oil level .....................................................page 74
● XDP drives. Checking of oil level ................................................................... page 80
● SX and DP-S drives. Power Trim pump. Checking of oil level ........................ page 76
● XDP drives. Power Trim pump. Checking of oil level ..................................... page 82
● Outboard drives. Servo pump. Checking of oil level ................................... not shown
● Reverse gear. Checking of oil level ................................................................page 71
Every 50 hours / at least once a year:
● XDP drives. Checking exhaust bellows. ......................................................... page 82
Every 200 hours / at least once a year:
● SX and DP-S drives. Change sacrificial anode ...............................................page 73
● XDP drives. Change sacrificial anode ............................................................ page 79
● SX and DP-S drives. Oil change ....................................................................page 74
● XDP drives. Oil change ............................................................................. page 80-81
● SX and DP-S drives . Grease CV joint and primary shaft bearing ............. page 77-78
● SX and DP-S drives. Checking CV joint and exhaust bellows. .......................page 77
● Reverse gear. Change oil and filter.................................................................page 71
To Next Page
Loading...
Need help?
General
