Valve positions
Fuel flow is controlled by moving the lever (1) to the
following positions:
A Normal running (both filters connected).
B Left filter insert can be changed.
C Right filter insert can be changed.
D Both filters turned off.
Changing the filter elements
If the engine is not running close the fuel cocks on the
tank before changing filters. If the engine is running cut
off the flow of fuel through the filter to be changed with
the handle (2) on the filter itself. Place a receptacle
under the filters.
1 Undo the T-bolt (3) remove the cover (4) and take
out the filter insert carefully while turning it.
2 Drain off water and contaminants through the drain
plugs (5).
3 Fit a new filter insert and fill the container with clean
fuel.
4 Change the gasket on the cover and the O-ring on
the T-bolt. Moisten the gasket and O-ring with fuel
before assembling.
5 Fit the cover and tighten it by hand. Wipe off any
fuel from the heat shield.
6 Change the other filter in the same way.
7 Open the fuel cocks and put the handle in position
for normal running. Make sure there are no leaks.
Maintenance
66 47713337 03-2021 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
