Speed factor
The speed factor for the boat´s paddle wheel speed
sensor can be adjusted at a resolution of 1% and is
used by the EVC to apply a correction to the output
from the speed sensor.
Set speed factor
Set speed factor while driving the boat. Compare
displayed speed with speed data from GPS (or other
boat) and adjust the speed factor until they corre-
spond.
Adjust the speed factor by turning the NAVIGATION
WHEEL.
Once adjustment value is reached, the data is stored
by pushing NAVIGATION WHEEL.
Information message
Start attempt with gear engaged
The engine control lever must always be in neutral
before starting. If not, this pop-up will be shown.
Approximated trip data
This pop-up will be shown every time after start-up ifstart-up ifif
FUEL FULL TANK CALIBRATION is performed.
Retrieving faults
The EVC system is retrieving faults from its nodes.
Monitoring mode (inactive station)
An inactive station can show system information.
Push MULTIFUNCTION BUTT ON on the inactivestation.
It is possible to navigate the menus when in monitor-
ing mode.
28
Instruments
To Next Page
Loading...
Need help?
General
