Maintenance Schedule
Your Volvo Penta engine and its equipment are designed for high reliability and long life. The engines are built to
withstand the
marine environment, but also to have the smallest possible environmental impact. If the engine and
transmission are serviced regularly according to the schedule, these qualities will be retained and unnecessary
malfunctions will be avoided.
Warranty inspection
During the initial period of use a special warranty inspection – a First service inspection – must be carried out by
an authorized Volvo Penta workshop. Instructions regarding how this must be done can be found in the Mainte-
nance Schedule below and in the Warranty and service book.
C
R
A
L
I
=
=
=
=
=
Clean
Replace
Adjust
Lubricate
Inspect (Clean, Adjust, Lubricate or Replace if nec-
essary)
S1, S2 = Special Interval Service
A, B, C, D = Type of service (regular service)
FSI
First Service Inspection, after 50–100 running hours
(1)
Coolant Level I
Fuel pre-filter, draining water / contamination I
Air filter insert I
Seawater filter I
Drive Belts I
Drive-unit, oil level I
Start and warm up engine
Engine and transmission, oil / fuel / water leakage I
1) Or within 180 days of the date of delivery, or the end of the first season, whichever comes first.
S2
After the First 1200 Hours
Valve clearance I
Every 50–500 Hours / at Least Every 12 Months
Engine Oil and Oil Filters / By-pass filter
(1)(2)
R
1) Oil change intervals vary, depending on engine type, oil grade and sulfur content of the fuel. Please refer to Oil Grade and
Oil Change Interval.
2) Change the filters during each oil change.
72 47702096 05-2011
To Next Page
Loading...
Need help?
General
