Fuel level
Fuel level can be displayed on the EVC system ta-
chometer if a (0-180 ohm or 240-30 ohm) fuel level
sender is installed in the fuel tank. The sender is con-
nected to the PCU–engine cable harness. If a fuel
level gauge is used it must be connected to the instru-
ment serial communication bus.
Fresh water level
Fresh water level can be displayed on the EVC sys-
tem tachometer if a (0-180 ohm) fuel level sender is
installed in the water tank. The sender is connected to
the PCU–engine cable harness. If a fresh water level
gauge is used it must be connected to the instrument
serial communication bus.
Rudder indicator
A rudder indicator sender is included in all drive-units.
The rudder angle can be displayed on the EVC sys-
tem tachometer. If a rudder instrument is used it must
be connected to the instrument serial communication
bus.
Multi sensor (Boat speed, depth and water temp)
Boart speed, depth and water temperature canbe dis-
played on the EVC system tachometer if a multi sen-
sor is installed on the boat. The sensor is connected to
the multilink cable. If instruments (speed, depth, water
temp.) are used they must be connected to the instru-
ment serial communication bus.
Boat speed
Boat speed can be shown on the EVC system ta-
chometer, if a multisensor or NMEA 0183/NMEA 2000
compatible component (plotter, GPS, paddle wheel
etc) is installed. If a speedometer is used it must be
connected to the instrument serial communication bus.
.
Trip computer
EVC supports trip computer functions if following are
installed.
- multisensor or NMEA 0183/NMEA 2000 compatible
component (plotter, GPS, paddle wheel etc)
- fuel level sender
- software for trip computer (order and download from
VODIA website).
Trip computer information can be displayed on the
EVC system tachometer or/and on the optional EVC
system display.
To Next Page
Loading...
Need help?
General
