Emergency shifting
If a fault occurs which prevents the drive-unit from
being operated (shifted) with the control lever it is
possible to shift manually using the description below.
WARNING! In emergency shifting, the unit is
locked in forwards operation. Please note that
the gear can not then be disengaged with the
control lever. Forward motion can only be cut off
by stopping the engine with the ignition key or
stop button.
This description is for manual engagement of the
drive-unit, for forward travel.
Manual engagement forward gear:
1. Stop the engine and remove the start key from
the key switch.
2. Note the valve to which the cable marked “Pri-
mary” (lower soleniod) is connected. Then undo
both connectors from the solenoid valves.
NOTE! P is forward and S is backward.
3. Remove the cap nut from the valve which was
connected to the “Primary” cable.
4. Press the valve (A) while turning the button a 1/2
turn counter-clockwise (the button is forced out
by spring action). The drive-unit is now connected
for forward motion and cannot be disengaged by
the control lever.
93
In case of emergency
To Next Page
Loading...
Need help?
General
