Calibration and Settings
Calibrating the Joystick Function
51321
This calibration only needs to be performed if the boat
movement does not correspond to the movements of
the joystick. Calibration only needs to be done in
one direction, port or starboard.
Calibrate the joystick function as follows:
1. Enable docking function. For additional infor-
mation, please see the section entitled Enabling
the Docking Function.
2. Push button 1 on the joystick and hold it down
for 5 seconds or more. A sound signal indicates
that the system is in calibration mode. The LEDs
above the buttons start to flash.
3. Move the joystick sideways to one of its end
positions. Correct the boat’s incorrect move-
ment by turning and/or moving the joystick as
illustrated in examples A–D. Combinations of
the examples shown can occur.
Let the boat move for quite a long distance
during the calibration routine. Hold the joy-
stick in position.
4. When the boat is moving directly sideways,
push the docking button 1. The new calibration
is stored and this is confirmed with a beep.
5. Release the joystick. The system is now in nor-
mal docking function. Joystick calibration is now
complete.
It is always possible to reset the calibration to factory
default as follows:
1. Enable docking function.
2. Push button 1 on the joystick and hold it down
for 5 seconds or more. A sound signal indicates
that the system is in calibration mode. The LEDs
above the neutral button start to flash, and the
LED above the docking button lights up.
3. Push the docking button 1. Calibration is reset
and this is confirmed with a beep.
4. The system is now in normal docking function.
47701898 12-2010 151
To Next Page
Loading...
Need help?
General
