Oil level, checking and topping up
The oil level must be inside the marked area on the
dipstick and must be checked daily before the first
start.
•
Top up with oil via the filler opening (1).
Check that the correct level has been achieved. If
the engine is stationary, wait for a few minutes to
allow the oil to run down into the oil pan.
•
Do not fill above the maximum oil level. Only use a
recommended grade of oil; refer to Technical
Data, page 85.
•
The oil level is only measured at the time the ignition
is turned on, not continually during operation.
Engine Oil, Change
WARNING!
Hot oil and hot surfaces can cause burns.
Oil changes must be done when the engine is hot.
1 Connect the drain hose to the oil drain pump and
check that no leakage can occur.
2 Pump the oil out (or remove the bottom drain plug
and drain the oil).
Collect all the old oil and old filters, and hand them
to a re-cycling station for destruction.
3 Remove the drain hose (or install the bottom drain
plug).
4 Fill with engine oil.
For change volume, please refer to Technical
Data, page 85.
Maintenance
47710925 01-2019 © AB VOLVO PENTA 61
To Next Page
Loading...
Need help?
General
