VTech Cory Carson User Manual

INCLUDED IN THIS PACKAGE
Toot-Toot Cory Carson ® Remote Control Cory
One remote control
One Parent’s Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy and should be discarded
for your child’s safety.
NOTE:
Please keep this Parent’s Guide as it contains important information.
Removing the Packaging Locks:
1. Turn the packaging locks anticlockwise several times.
2. Pull out the packaging locks and discard them.
1. Rotate the packaging locks 90 degrees anticlockwise.
2. Pull out the packaging locks and discard them.
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a screwdriver to loosen the screw.
3. If used batteries are present, remove these batteries from the unit by pulling up one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram inside the battery box.
(For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
Remote Control
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a screwdriver to loosen the screw.
3. If used batteries are present, remove these batteries from the unit by pulling up one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram inside the battery box.
(For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly is required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION

VTech Cory Carson Specifications

General

Brand	VTech
Model	Cory Carson
Category	Toy
Language	English