72
Appendix
Expand your telephone system
The handset provided with your telephone system is pre-registered as
HANDSET. Additional handsets registered to the telephone system are
assigned in sequential order. If you register another new handset to your
telephone system, the new registered handset is assigned HANDSET 2.
This telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets (DS6101, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When rst purchased, each expansion handset shows
Press [HOLD] on base for 4 sec, then press [#] on handset
. You may
need to charge the handset before registering to the telephone base. For
more details on battery charging, see the table on page 5.
To register a handset:
Place the unregistered handset in the telephone base. If Press [HOLD]
on base for 4 sec, then press [#] on handset does not appear on the
handset screen after a few seconds, remove the handset and place it in
the telephone base again.
Press and hold HOLD on the telephone base for about four seconds
until the telephone base displays Registering handset, then, while
the handset is still in the telephone base, press # on the handset. The
handset shows Registering... Please wait and it takes up to 60 seconds
to complete the registration. The handset and the telephone base show
HANDSET X Registered (X represents the handset number assigned)
and you hear a beep when the registration completes.
1.
2.
If the registration fails, the handset shows Registration failed. To reset the
handset, remove the handset from the telephone base and place it back in.
Try the registration process again.
You cannot register a handset if any other system handset is in use.
•
•
HOLD
#
To Next Page
Loading...
Need help?
General
