11
11
11
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install with a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in
Canada, or by going to our web site at vtechkids.com and filling
out our Contact Us form located under the Customer Support link.
Creating and developing VTech
®
products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for
you to know that we stand behind our products and encourage you
to contact us with any problems and/or suggestions that you might
have. A service representative will be happy to help you.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
theequipment.
NOTE
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
To Next Page
Loading...
Need help?
General