VTech Touch & Chat Light-Up Phone User Manual

4
4
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery box. For best performance,
alkaline batteries or fully charged Ni-MH rechargeable batteries are
recommended.
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.
WARNING / ATTENTION:
Adultassemblyrequiredforbatteryinstallation.
Keep batteries out of reach of children.
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

VTech Touch & Chat Light-Up Phone Specifications

General

Brand	VTech
Model	Touch & Chat Light-Up Phone
Category	Toy
Language	English