Go to www.vtechphones.com
to register your product for
enhanced warranty support
and latest VTech product news.
VM342-2
Quick start guide
What’s in the box
Install the battery
Press 7*&8 to switch between the image of baby units and .
Press7*&8
Change different views - View
Change different views - Patrol
Press 1"530- to alternately view the image from baby units and every 10 seconds.
10s
Change different views - Split
Press 41-*5 to view the images from all baby units at once.
Dim mode
With dim mode preset to on, your parent unit display will dim after 10 minutes of inactivity to conserve energy.
10 min inactivity
Press any buttons
Connect and power on - Baby unit Connect and power on - Parent unit
CAUTION
The default volume of your parent unit
is level 4. If you experience high-pitched
screeching noise from your baby monitor
while positioning:
Make sure your baby units and parent unit
are more than 1 meter (3 feet) apart, OR
Turn down the volume of your parent unit.
•
-
-
6U
]KXOTMUT
2s
Once you power on your baby monitor, your parent unit displays image from baby unit , and the -*/, LED
light turns on.
The 0/0'' LED light of baby unit
turns on. As baby unit is not being viewed, its 0/0'' LED light flashes.
Status check
63ē
5)*44*%&61
VM342-2 baby monitor system
Baby’s room Living room
> 1m (3ft)
63
ē
63
ē
> 1m (3ft)
< 1m (3ft)
Install the lens (optional)
The wide-angle lens (7.) provided allows you to view
more of your baby’s room from the parent unit screen.
If you do not use the lens at the moment, put
the lens cover on the lens to avoid scratches.
To Next Page
Need help?
General
