EH 23, 27 Safety
17
Safe working with the hammer
Keep the tool holder closed during operation.
Guide the power cable always from the machine to the rear and keep the power
cable away from the working range of the machine.
3.7 Safety during the operation of electric appliances
Specific regulations for electrical appliances
Observe the safety information provided in the brochure General Safety Rules
which is included in the scope of delivery of your machine.
Also observe the country-specific regulations, standards and guidelines in refer-
ence to accident prevention in connection with electrical equipment and ma-
chines.
WARNING Read all safety information and instructions. Failure to follow
the safety information and instructions may result in electric shock, fire and/or se-
rious injury.
Save all safety information and instructions for future reference.
Electric power supply for electrical appliances of class rating II
Note: The rated voltage is indicated on the nameplate of your machine.
The machine may only be connected to an electric power supply with all machine
parts in proper working condition. Take special notice of the following compo-
nents:
Plug.
Power cable over the entire length.
Switch diaphragm of the ON/OFF switch, if there is one.
Plug receptacles.
Electrical appliances of class rating II have a strengthened or double insulation
(protective insulation). They have no connection to the grounded conductor.
There must be at least one of the following safety devices if connected to a sta-
tionary or mobile generator:
Fault current protective switch.
Isolation (earth leakage) monitor.
IT-net.
Note: Observe the respective national safety regulations!
To Next Page
Loading...
Need help?
General
