1A-17
G50/G70/G85 OPERATION 1A
When an overload condition is sensed in any leg, the engine will shut down and the LCD panel will display the fault
condition shown above.
Before restarting the generator the cause of the overload should be determined and eliminated. Review all loads
attached to the generator and make sure they do not exceed the power rating of the unit.
1.13 Current Overload Fault
Along with engine functions the ECM continuously monitors the current load in each phase. The values for current
overload are programmed into the ECM at the factory and are different for each generator size.
V
A
Hz
Ø
FAULT
OVERLOAD
To Next Page
Loading...
Need help?
General
