D
David RomeroAug 4, 2025
Why is my Wacker Neuson MP15 Construction Equipment plate not developing full speed?
- FfarrellamyAug 4, 2025
If your Wacker Neuson Construction Equipment plate isn't reaching full speed and compaction is poor, several factors could be at play. First, ensure the engine throttle control is fully open and correctly adjusted. If the ground is too wet, allow it to dry. Check the drive belt for looseness or wear, adjusting or replacing it as needed and ensuring the engine mounting bolts are tight. Inspect the exciter for binding, checking the oil level and condition, adding or changing the oil if necessary. Clean or replace the air filter if it's clogged with dust. Finally, verify the engine speed with a tachometer, adjusting or repairing the engine to run at the correct speed, consulting the engine manual if needed.