© Wagner Spray Tech. All rights reserved. 3
English
Introduction
This spray gun is designed for use as a High Volume/Low Pressure
(HVLP) painting system.
With an HVLP system, the highest quality professional nish can be
achieved with little preparation or setup time. HVLP systems are
not intended to replace airless systems. Instead, they are meant to
compliment airless by improving the nal nish on the substrate,
minimizing waste, and reducing labor time.
This HVLP spray gun with regulator is designed to be used with an
air compressor. Please review all the information contained in this
manual before operating your HVLP spray gun.
Air Cap Ring
Air Cap
Cup Locking
Lever
1-Quart Cup
Assembly
Check Valve
Trigger
Packing Nut
Regulator
Material Flow
Adj. Knob
Pressure
Gauge
Fluid Inlet
NOTE: The cup locking lever secures the cup to the spray
gun.
Using an HVLP Spray Gun
Preparing to Spray
1. Release the cup locking lever and remove the cup.
2. Make sure that the cup and the cup gasket is clean and in
position. Fill the cup with the desired painting material.
3. Place the cup on the spray gun and tighten the cup locking
lever.
4. Attach the air supply hose to the air inlet tting at the bottom
of the gun handle.
5. Turn on the air supply.
Selecting a Spray Pattern
The spray pattern is adjusted by turning the air cap into either a
vertical, horizontal, or diagonal position. To turn the air cap, grasp
the two front tabs and twist. Never trigger the gun while adjusting
the spray pattern.
Horizontal
Pattern
Vertical
Tip Position
Round
Pattern
Diagonal
Tip Position
Vertical
Pattern
Horizontal
Tip Position
To Next Page
Loading...
Need help?
General
