English
© Wagner Spray Tech. - All Rights Reserved 5
Material Preparation
Note: Material to be sprayed may need to be strained
to remove any impurities in the paint which may enter
and clog the system. Impurities in the paint will give
poor performance and a poor finish.
Note: Only thin the material if absolutely necessary to
improve spray performance (or if advised by coating
manufactuer). Optimal spray performance should be
acheived simply by adjusting the various controls on
the unit.
To Prepare the Material:
1. Stir the spraying material thoroughly.
2. Unscrew the cup from the nozzle.
3. After the material has been properly thinned and
strained, ll the container to desired level.
Thinning the material:
For certain spraying situations or desired nishes,
thinning the material may be desired. It is not necessary
for most materials when used with the iSpray nozzle.
For use with the Detail Finish nozzle thinning may be
needed to acheive a ner nish. Make sure you adjust
the X-Boost™ and Material ow settings for your specic
material needs.
If thinning is necessary, use the proper solvent as
specied by the material manufacturer. Never exceed
the thinning advice given by the coating manufacturer.
Do not thin with materials that have
a ashpoint below 100°F (38°C). The
material ashpoint should be shown on
the material container.
1
3
2
To Next Page
Loading...
Need help?
General
