8
English
1
. Elevate roller arm and hang from an empty bucket. The
unit must be lower than the arm in order for air to be
c
ompletely purged from the paint hose
(
DO NOT
SUBMERGE ROLLER HANDLE).
2
. Flip selector switch to
C
LEAN
(
motor will run continuously
without the aid of the handle button). Run a minimum of
o
ne gallon of soapy, lukewarm water through the unit
(cleaning time may vary depending upon type of paint
used).
3. While unit is self-cleaning, thoroughly clean the roller
cover, core and cap.
4. Remove suction tube from solution, raise
UNIT above
HANDLE, and run motor until all cleaning solution is
purged from the unit. Flip selector switch to OFF (O) and
unplug the power cord.
A light paint film residue may remain in the paint hose
after cleaning. This is normal and will not affect the
future performance of your unit.
5. Press quick-release tabs and remove the roller arm from the roller handle. Remove any remaining paint with the appropriate
cleaning solution and a damp cloth
(DO NOT SUBMERGE HANDLE!).
Follow these steps ONLY if you used latex materials and do not have a garden hose available.
Optional Cleanup - latex materials
*The empty bucket should be
larger than the cleaning bucket.
Switch the unit OFF (O) prior to removing any
accessories or components, and make sure your floors
and furnishings are protected from dripping paint.
To Next Page
Loading...
Need help?
General
