English
13
Spraying
Troubleshooting -
Clean the Spray
Gun Filter
Start
You will need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement spray gun lter (if necessary)
IMPORTANT: Never clean the filter by
poking it with a sharp object.
1. Peform the Pressure
Relief Procedure, page 7.
5. Inspect the lter for
damage. Replace if any
holes or tears are found.
4. Remove the lter from the
housing. Clean with appropriate
cleaning solution (warm, soapy
water for latex materials; mineral
spirits for oil-based materials).
2. Pull trigger guard
from lter housing.
6. Replace cleaned lter, tapered
end rst, into the gun housing.
Note: It is important to place tapered
end rst to ensure proper sprayer
operation.
3. Tighten the wrench over the
wrench ats (a). Unscrew the
lter housing using a wrench.
Note: You DO NOT need to
remove the spray hose from the gun
to clean the lter.
7. Reassemble the spray gun.
To Next Page
Loading...
Need help?
General
