English
5
Proper
use and
functions
Start
Controls and Functions
ON/OFF switch:
The ON/OFF switch turns power
to sprayer on and off.
(O=OFF, |=ON)
PRIME/SPRAY knob:
The PRIME/SPRAY knob directs
material to the material return
tube when set to PRIME or to
spray hose when set to SPRAY.
Spray hose:
The spray hose connects the
spray gun to the pump.
Pressure control:
The pressure control function is
also controlled by the PRIME/
SPRAY knob. The pressure
control regulates the amount
of force the pump uses to push
the uid and can be adjusted for
desired spray pattern.
Spray gun:
The spray gun controls the
delivery of the material being
pumped.
Trigger lock:
Engage the trigger lock whenever
the gun is not in use.
The gun is locked when the
trigger lock is at a 90º angle
(perpendicular to the trigger in
either direction).
Material return tube (a):
Fluid is sent out through the
return tube and back into the
original container when the
PRIME/SPRAY knob is in the
PRIME position.
Suction tube (b):
The suction tube draws the uid
from the original container into
the pump.
Sprays a variety of paints (oil-based and
latex), primers, stains, preservatives and other
nonabrasive materials. Do not use materials
with ash points below 70° F (21° C)
Do not use!
This pump should not be used with textured
materials, block ller, lacquers, industrial
enamels, or asphalt sealer or materials
containing HHC. See coating supplier if ash
point is not listed on the container
Safety features:
Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob
for safe pressure release. Conforms to ULSTD
1450. Certied to CAN/CSAC 22.2 NO 68-92
Specifications
Weight ................................28.5 lbs
Flow rate .............................0.24 gal/minute
Power source......................1/2 Hp universal
motor
Power requirement .............15 amp minimum
circuit on 120 VAC,
60 Hz current
Generator requirement .......5000 Watt
Max. spraying pressure ......2800 PSI
Capability:
To Next Page
Loading...
Need help?
General
