WAGNER Project 115 User Manual

16
Project 115
Figure20-CleaningtheInletValve(Kitpartnumber
0418714)
i
Cleaning or servicing the inlet valve may be required if
the unit has priming problems. Priming problems may
be prevented by properly cleaning the sprayer and
following the long-term storage steps.
 1. Removethehopper.Loosenthelocknutbyturning
anticlockwise.
2. Remove the inlet sleeve (1) with a suitable tool (e.g. socket SW
11).
3. Inspect the threads on the inlet sleeve and the inlet sleeve
O-ring(2).Removeanyaccumulatedpaint.
 4. Toremovetheinletvalve,placetheassemblyaid(8)ona
socket (6) with a 5/8” insert (7). Insert the inlet valve tool into
theinletvalve(a).Removetheinletvalvescrewconnectionby
unscrewing anticlockwise from the housing.
 5. Retrievetheinletvalve(9)andtheinletvalveO-ring(10)from
the inlet valve housing. Clean or replace and lubricate the
O-ringwithalighthouseholdoil.
 6. SettheinletvalveO-ring(10)backintothehousing,andset
the inlet valve (9) on top of it.
7. Replace inlet tting (8) into the housing. Tighten with the
inlet valve tool (7) and ratchet (4, 5, 6).
 8. Replacetheseal(3).PlacetheinletsleeveO-ring(2)onto
theinletvalvetting(9),andreplacetheinletsleeve(1)by
twisting it clockwise.
9. Replace the hopper.
Figure21-CleaningtheOutletValve
Cleaning or replacing the outlet valve may be necessary if your
spray performance remains poor after having performed all the
steps contained in the Troubleshooting section of this manual.
1. Unscrew the outlet valve from the outlet valve housing using
an adjustable wrench.
 2. Inspecttheinsideoftheoutletvalvehousing(a).Cleanany
accumulated paint.
3. Replace with a new outlet valve. Tighten into outlet valve
housing with an adjustable wrench.
Parts Lists
Figure22-SprayGun/SprayHose
Item Part # Description Quantity
 1 0418717 Gunassembly(withoutnozzle) ....................1
2 0418705 Tip, XS ......................................................................1
2 0418708 Tip, L .........................................................................1
3 0418711 Filter, XS-S (red) ...................................................2
 3 0418712 Filter,M(yellow) ..................................................2
 4 0418718 Sprayhose,7.5m,red ........................................1
Part # Description
 0418705 Spraytip,XS .....................Water-soluble and solvent
based enamels and paints, oils
and release agents
 0418706 Spraytip,S .......................Syntheticresin-basedpaints,
PVC paints
 0418707 Spraytip,M ......................Enamel paints, undercoats,
primers, llers, indoor latex
paints and indoor emulsions
 0418708 Spraytip,L .......................Enamel paints, undercoats,
primers, llers, indoor latex
paints and indoor emulsions,
anti-corrosive paints
0418711 Filter, XS - S (red, 2 pack)
 0418712 Filter,M(yellow,2pack)
0418713 Filter, L - XXL+ (white, 2 pack)
0418714 Valve set (inlet and outlet valve)
All spare parts listed above are wear parts, and are not covered
by warranty!

WAGNER Project 115 Specifications

General

Brand	WAGNER
Model	Project 115
Category	Paint Sprayer
Language	English