14
Table 1- EH-DC and EHASR-DC Replacement Parts
12Vdc Solenoid
Valve Coil
Cad Cell - 12" +
Tubes for gun
mount
13.5Vdc Igniter-
Solid State
Igniter Drop-Out
Timer Relay
Brass Connector
90° Elbow
Kit-13.5Vdc Igniter
plate assembly
Cast Iron - 3
9/16" No Vane
13.5Vdc Wayne Oil
Primary Control
Cast Iron - 3 3/4"
No Vane
Pump – A2VA-
3006/12Vdc SOL.
NOTE: STATE SPECIFICATION NUMBER, BURNER MODEL, PART DESCRIPTION WHEN ORDERING PARTS, THIS DICTATES WHAT PART IS
NEEDED FOR YOUR BURNER SPECIFICATION NUMBER
1) Cast Iron Cones - Measure machined ID. Stainless Steel Air Cones - Number/Letter combination stamped into face of outer ring.
2) Item 15B are oil pumps that come with oil solenoid valves already attached, but replacement parts (item 16B) are available for replacing the fuel
solenoid coil.
3) Item 15A are oil pumps that do not come with solenoid valves, solenoid valves are optional for these model. If oil pump comes with a solenoid
valve (item 16A), item number 18A must be used. If oil pump does not come with a solenoid valve, brass connector elbow 18B must be used.
4) 13.5Vdc Igniter kit assembly includes items 5, 6, 8 and 17 fully assembled on a new burner mounting plate.
= Item not available for purchase on that specific burner model
To Next Page
Loading...
Need help?
General
