Installation
Unpacking and Inspection
When the equipment is received, all items should be carefully checked according to the packaged components list
within this manual to ensure all components have been received. Examine components for shipping damage. If the
unit is damaged, the carrier should make the proper notation on the delivery receipt acknowledging the damage.
Safety Considerations
VERY IMPORTANT: Never install your air conditioner in the bilge or engine room areas. Ensure that the selected
location is sealed from direct access to bilge and/or engine room vapors. Do not terminate condensate drain line
within 3’ (914mm) of any outlet of engine, generator exhaust system, compartment housing an engine or generator,
or in a bilge, unless the drain is connected properly to a sealed condensate or shower sump pump. Seal all cabin
penetrations around condensate hoses to eliminate harmful bilge fumes in the cabin living spaces.
Installation and servicing of this system can be hazardous due to system pressure and electrical components.
When working on this equipment, always observe precautions described in the literature, tags and labels attached
to the unit. Follow all safety precautions. Wear safety glasses and work gloves and place a fire extinguisher close
to the work area. The following is a summary of the labels on the unit:
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
Special note. Make sure to read before proceeding.
Electrical shock hazard. Disconnect voltage at main panel or power source before
opening any cover. Failure to comply may result in injury or death.
This component does not meet federal requirements for ignition protection. Do not install in
spaces containing gasoline engines, tanks, LPG/CPG cylinders, regulators, valves or fuel
line fittings. Failure to comply may result in injury or death.
Notice the 115V series and the 230V series are charged with Hydro fluorocarbon (HFC)
refrigerant R410A. Effective July 1, 1992, it shall be unlawful for any person to knowingly vent
or otherwise knowingly release any class 1 (CFC) or class 2 (H CFC) substance as a
refrigerant in a manner which permits such substance to enter the atmosphere per the clean
air act of 1990. Public law 101-549 title IV section 608-c. Failure to comply may result in
severe penalties, including fines and imprisonment.
To minimize the hazard of electrical shock and personal injury, this component must be
effectively grounded. Refer to the installation guidelines for further information. Caution! High
compressor temperature is normal. Do not touch!
To Next Page
Loading...
Need help?
General
