ThermoConnect 9
Output 2 (Pin 11) to the car ventilation
control.
Add another control button in the mobile
app via the "My WebastoConnect" service.
The button will then appear in the mobile
app automaticaly.
Heating still controls ventilation automati-
cally: the user must not use both heating
and ventilation controls simultaneously.
11 ThermoConnect identification
label
Fig.12 Example: label with QR code
The ThermoConnect identification label is
needed to pair the mobile app with the
ThermoConnect device.
1
Fig.13 Example: location doorpillar
Attach one label to a place where it can
be scanned using the phone camera.
For example to the vehicle A- or B-pil-
lar, the side of the dashboard or on the
fuse compartment lid.
Attach the other label on Fig.23.
12 Initial start-up
12.1 Install the app on mobile
phone
Fig.14 ThermoConnect app
Example of the app on a mobile phone
On mobile phone, check if the mobile
phone is connected to a network (an
internet connection must be available).
Go to the relevant app store. Search
for 'ThermoConnect'. Apple App
Store and Google Play have the app
available. This step can also be per-
formed by using the QR code.
- Apple App Store see Fig.15
- Google Play see Fig.16
Install the ThermoConnect mobile app
on the phone.
Connect the phone with the
ThermoConnect following the instruc-
tions on the mobile phone app. During
this step the QR code on the vehicle or
on the back of this manual needs to be
scanned. The ThermoConnect app will
ask for this step.
GET IT ON
Google Play
Fig.15 Apple iOS Fig.16 Android OS
To Next Page
Loading...
Need help?
General
