UniControl 6
5 Initial start-up
5.1 Information on initial operation
WARNING
Inhaling poisonous gases in the enclosed
rooms
Danger of poisoning and suffocation
Never operate the heater (also not with program-
med heating start) in closed rooms such as ga-
rages or workshops that do not have an exhaust
extraction unit.
In workshops with exhaust extraction facilities,
make sure that the exhaust extractor is fully
operational.
WARNING
Hazardous substance transportation (ADR):
programmed heating start not permitted
Select and confirm ADR function in the menu.
See „6.3 Select ADR function“ on page 7.
Observe additional provisions for the installation
of the control element in vehicles for hazardous
substances.
3
Heater is correctly installed.
3
Control element is correctly installed.
3
Vehicle on-board power supply is connected to the battery
voltage.
Select heater
Is omitted if the heater is automatically detected
Rotate the control knob and select the installed heater.
+HDWHU
Fig. 04: "Heater" menu element
Press the control knob.
Setting the day of the week:
Mon
Fig. 05: Day of the week
Rotate the control knob, select weekday.
Fig. 06: Setting the time
Setting the time:
Rotate the control knob, set the hour.
Press the control knob.
Rotate the control knob, set the minutes.
Press the control knob.
Heating
Fig. 07: Main menu
When the main menu is displayed, initial start-up is completed.
The selected heater can be changed at a later date
using the Service menu. See „6.2 Manual heater
selection“ on page 7.
To Next Page
Loading...
Need help?
General
