UniControl 7
6 Service menu
6.1 Bringing up the Service menu
On initial start-up
As for reset option, all settings are restored to
factory settings (standard settings are configured
by a service technician) except a day of a week and
an hour.
Select the “Settings” symbol from the main menu.
Settings
Fig. 08: "Settings" menu element
Press the control knob.
Select the "Reset" menu element.
Reset
Settings
Fig. 09: "Reset" menu element
Press the control knob.
Reset
Settings
Fig. 10: "Confirm reset" menu element
Press the control knob again to confirm the menu selection.
Immediately press the control knob and quick start
button simultaneously for 3 seconds.
The Service menu is shown.
Heater
Fig. 11: "Heater" menu element
Rotate the control knob clockwise to select the menu elements.
6.2 Manual heater selection
Bring up the Service menu.
Heater
Fig. 12: "Heater" menu element
Press the control knob.
Heater
Fig. 13: "Heater" menu element, example Thermo 90 ST
Information on selecting the appropriate heater can
be founded in the table in the supplementary sheet.
Rotate the control knob and select the installed heater.
Press the control knob; the heater has been selected.
Rotate the control knob counterclockwise and select “Back”.
Press the control knob.
6.3 Select ADR function
Bring up the Service menu.
Rotate the control knob clockwise.
Select the "ADR" menu element.
Fig. 14: "ADR" menu element
Press the control knob (select ADR “On” or “Off”)
Rotate the control knob counterclockwise and select “Back”.
“Off”: UniControl with timer function (factory
setting)
“On”: UniControl has no timer function.
To Next Page
Loading...
Need help?
General
