11
ENGLISH
Need help? www.weboost.com Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
Lightning
Surge Protector
(sold separately)
To Outside
Antenna
To Signal Booster
Ground Wire
(not included)
!
RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR
(SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL
BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE
SURGE PROTECTOR. ENSURE THE LSP IS PROPERLY GROUNDED.
#859992-75 OHM MAY BE PURCHASED AT WWW.WEBOOST.COM OR BY
CALLING 800-204-4104.
Signal Booster Specifications
Connect 3G
™
Model Number 472005
Connectors F-Female
Antenna Impedance 50 Ohms
Frequency 824-894 MHz / 1850-1990 MHz
Passband Gain (nominal)
800 MHz
Band 5
60.3
1900 MHz
Band 2
60.4
20 dB Bandwidth (MHz)
800 MHz
Band 5
1900 MHz
Band 2
Typical
Maximum
40.8
41.1
74.7
75.0
Power output for single cell phone (dBm)
800 MHz
Band 5
1900 MHz
Band 2
Uplink
Downlink
24.9
-2.2
22.5
-2.1
Power output for multiple received channels
(Uplink) dBm
No. Tones
800 MHz
Band 5
1900 MHz
Band 2
2 24.8 20.2
3 21.3 16.7
4 18.8 14.2
5 16.9 12.3
6 15.3 10.7
Power output for multiple received channels
(Downlink) dBm
No. Tones
800 MHz
Band 5
1900 MHz
Band 2
2 1.3 3.5
3 -2.2 -0.1
4 -4.7 -2.6
5 -6.6 -4.5
6 -8.2 -6.1
Noise Figure (typical downlink/uplink) 3 dB nominal / 6 dB nominal
Isolation > 90 dB
Power Requirements AC / DC 6V, 2.5A, w/2.5x5.5mm Jack
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.