2
CELL PHONE SIGNAL BOOSTER CONNECT 4G-X
ENGLISH
______
Step 1: Preparation
NOTE: These instructions will walk you through a “soft” install process to fi nd the
optimal locations for the inside and outside antennas, then through the process of the
permanent installation.
You Will Need (tools not included)
Make sure the following materials are prepared and ready for your installation.
Ladder
Phillips-head screwdriver
10mm open-end wrench or adjustable wrench
Drill (if routing cable through wall)
Mounting Option
A
: 1-2” diameter pole (#901117) or an
existing pole
Recommended: Power Strip with surge protection
2 to 3 hours
2 people (a person to help with antenna calibration)
To Next Page
Loading...
Need help?
General