EasyManuals Logo

Windsor 12” Sensor2 User Manual

Windsor 12” Sensor2
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background image
16
Maintenance
Maintenance and Service
ALWAYS unplug from the mains socket before
dismantling any part of the machine.
Bag Full Indicator
If the warning indicator (4) turns orange, it indicates
that there is a reduced air flow. This is caused either
by dirty filters, a blockage in the hose or base of the
machine, or a full paper bag. When picking up fine
dust, it may be necessary to change the dust bag
before it is full. Fluff or hair lets air pass through
easily, the bag may overfill before the full indicator
comes on.
Changing the Paper Bag
To change the paper bag, press the catch (15) and
remove the bag cover (29). Push the lever (30) over
to the right. Then change the bag, as illustrated on
front of bag. Ensure that the bag top (47) is located
properly on both sides of the holder (46) and pushed
until it locks. The used paper bag can be sealed with
a cap.
NOTE: Do not re-use paper bags.
NOTE: Use only manufacturer approved filters and
bags
To fit a new dust bag, Slide the right side of the bag
top into the holder (46) and fit the dust inlet of the bag
top (47) over connecting tube until the filter bag
latches into the lever.
Changing the Filters
The Microfilter (37) is located in the dust bag
compartment. To change the Microfilter slide it out.
Please ensure no particles fall down into the swivel
neck. To insert a new Microfilter (37) lift the metal
bar (38) to slide the filter in.
4
15
29
37
38
30
46
47
86400000 - Sensor2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Windsor 12” Sensor2 and is the answer not in the manual?

Windsor 12” Sensor2 Specifications

General IconGeneral
BrandWindsor
Model12” Sensor2
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals