RapidMatch
™
XI Spectrophotometer
5
1. Carefully turn the instrument over and slide open the latch (1) that
secures the battery pack access cover. Open the access cover.
2. Slide the new battery pack (2) into the instrument with the battery contacts
facing down until the battery is positioned below the holding latch (3).
3. Close the access cover by pressing down until it locks into position.
4. Powering On
Press the power on/off and measure button
or plug in the power adapter to turn on the
instrument. If the instrument does not power
up after pressing the power button, the
batteries may require charging.
You can press and hold the button for three
seconds, and then tap Power Off in the
display to turn off the instrument.
5. Charging the Battery Pack
General
• The battery pack for your new instrument comes in a low to medium
charge state and should be charged before use (up to 4 hours for full
charge).
• A charged battery pack may eventually lose partial charge if not used
for an extended amount of time. You should charge the battery from
time to time and store in a cool environment when not in use to
maintain battery performance.
• The battery pack can be charged in the instrument (Refer to Section 6
Connecting the Power Adapter) or by use of the optional charging
station. The charging station is useful for charging up to two battery
packs.
• Battery Charge Temperature Range 5°C to 40°C.
To Next Page
Loading...
Need help?
General
