2322
Notes:
If your audio/video component does
not respond, try the other codes for your
brand. If it still doesn’t respond, try the
Code Search method below.
If the LED blinked rapidly when you
entered the code, you may have entered
an invalid code. Recheck the code in the
code list and try again.
S
EARCHING
F
OR
C
ODES
1. Turn on the device
you want to control.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Press the mode
button that matches
the equipment you
want to control. The
LED blinks once.
4. Press CHANNEL +
repeatedly* until
the device to be
controlled changes
channel.
If you go past the
code accidentally,
just press LAST
repeatedly until the
channel changes
again.
5. Press and release
the ENTER button to
complete the setup.
U
SING
AUX
TO
CONTROL
A
S
ECOND
TV, VCR, C
ABLE
B
OX
OR
S
ATELLITE
R
ECEIVER
The AUX button is normally used to
control an audio component, but it can
also be configured to control a second
TV, VCR, cable box or satellite receiver.
4. Press and release
the mode button
that matches the A/
V equipment you
want to control. The
LED blinks once.
1. Turn on the
equipment you wish
to control.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Press the AUX1 or
AUX2 button.
5. Enter the 3 digit
Code from the
Library Code
Tables. The LED
turns off after the
last digit entered.
6. Point the remote at
your audio
component and
press the POWER
button. Your audio
component should
turn off.
7. Turn your audio
component on and
press CHANNEL +.
If it responds, setup
is complete.
To Next Page
Loading...
Need help?
General
