X10 SUPERREMOTE UR19A User Manual

98
1. Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2. Plug a lamp into
the Lamp Module.
3. Plug the Lamp
Module into a
convenient AC
outlet.
6- IN -1 S UPER R EMOTE
The 6-in-1 SuperRemote allows you to
control practically everything electrical in
your home. It has IR technology that lets
you control all your TV, VCR, Cable and
Satellite equipment, and X-10 RF
technology that lets you control lamps
and appliances anywhere in your home.
To find out more about configuring the
SuperRemote to work with your audio/
video equipment, see the section titled
“Setting Up your SuperRemote.”
1. Push the tab and lift
off the battery
cover.
2. Fit two AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
INSTALLING THE
COMPONENTS
T
RANSCEIVER M ODULE
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from the SuperRemote to operate a lamp
or appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X-10 modules (also sold
separately). Note that unlike the Lamp
Module you cannot dim and brighten a
lamp connected to the Transceiver
Module.
You should locate the Transceiver Module
centrally in the home for maximum range
when controlled by the SuperRemote.
2. Plug a lamp or
appliance into the
Transceiver
Module.
3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
L AMP M ODULE
The Lamp Module may be used to
control any incandescent lamp rated up
to 300W. It is not suitable for other types
of lamp such as fluorescent or energy
saving lamps, or lamps which include a
dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the Lamp
Module. It may damage the module and
the appliance and could cause a fire
hazard.
1. Set the House Code
to ‘A.’

X10 SUPERREMOTE UR19A Specifications

General

Brand	X10
Model	SUPERREMOTE UR19A
Category	Remote Control
Language	English