97-0022-01-01 27
Operation of the Xanbus System Control Panel
Types
There are two types of warning messages: manual and automatic.
Each differs in its behavior and appearance. For a list of SCP warnings and
their associated types, refer to “Troubleshooting” on page 31.
If you see a warning message on the SCP, you will have to acknowledge it
and (if necessary) clear it. Acknowledging the warning allows you to
continue operating the SCP. Clearing the warning message stops the
warning condition from escalating into a fault.
Acknowledging Warning Messages
Automatic warnings Acknowledging an automatic warning message
removes the message from the SCP screen.
To acknowledge an automatic warning message, press Enter. After you
acknowledge the warning, the SCP displays the menu for the device that
caused the warning.
The SCP removes an unacknowledged automatic warning message from the
screen after three minutes. However, if the condition that caused the
warning still exists, the warning message will reappear.
You can view a list of the last 20 warning messages from the SCP on the
Warning log. See “Viewing the SCP Warning Log” on page 28.
Manual warnings A manual warning message requires you to make a
choice (usually by pressing Enter for “yes” or Func for “no”) before you
can proceed monitoring or configuring the SCP. It will not disappear after
three minutes. After you respond to the warning message the SCP clears the
warning message and returns to the screen it was displaying before the
warning message appeared.
Clearing Warning Messages
Automatic warning messages clear when the warning condition on the SCP
disappears or when the criteria for clearing the warning are met.
You can clear a manual warning message by pressing Enter or Func in
response to the message.
Viewing Multiple Warning Messages
If several warning messages occur before you can acknowledge or clear
them, they are displayed together on a warning list. The warning list
contains messages from every Xanbus-enabled device, not just the SCP.
You can select a message from the warning list and view its details.
To view a message from the warning list:
1. On the warning list, use the up arrow or down arrow button to
highlight the warning message you want to view.
2. Press Enter.
The complete warning message appears.
After viewing the warning message, you can return to the warning list by
pressing Func or continue to the menu for the device that caused the
warning by pressing Enter. Each time you return to the warning list after
viewing a complete message, the viewed message is removed from the list.
If you have left the warning list, you can view it at any time from the
System Settings menu.
To Next Page
Loading...
Need help?
General
