28 Xanbus System Control Panel (SCP) Owner’s Guide
Operation of the Xanbus System Control Panel
To view the warning list:
1. On the Select Device menu, highlight System Settings and
press Enter.
2. On the System Settings menu, highlight View Warning List and
press Enter.
Viewing the SCP Warning Log
The SCP warning log displays the 20 most recent warnings that the SCP
generated. These warnings can be both active and cleared. Each warning in
the log is identified by a warning code and the time that it occurred. You
may need to refer to the warning log before consulting “Troubleshooting”
on page 31, or before you call technical support.
To view the warning log:
1. On the SCP menu, press the down arrow button to highlight View
Warning Log.
2. Press Enter.
To return to the SCP menu:
◆ From the Warning log, press Func.
Viewing Individual Warning Messages from the Warning
Log
On the warning log, you can also select an individual warning and view its
details.
To view details for a warning:
1. Use the up arrow or down arrow button to highlight the warning
message you want to view.
2. Press Enter.
The complete message appears.
To return to the warning log:
◆ Press Func (as indicated by the arrow marked “cancel”).
To proceed to the device menu and adjust device settings to eliminate
the warning condition:
◆ Press Enter (as indicated by the arrow marked “continue”).
Figure 12
SCP Warning Log
Warning Log: XSCP
250 May/13 10:58PM
252 May/10 10:15AM
250 Apr/30 4:06PM
250 Apr/28 12:00PM
To Next Page
Loading...
Need help?
General
