97-0022-01-01 29
Operation of the Xanbus System Control Panel
Fault Messages
Fault messages appear when the SCP’s operation is affected by a condition
that requires immediate attention. When a fault occurs, the SCP stops
operating until either the fault condition goes away or until you manually
clear the fault and take action to eliminate the fault condition.
Types of fault messages
There are two types of SCP fault messages: automatic and manual. For a list
of faults and their associated types, refer to “Troubleshooting” on page 31.
Automatic faults clear themselves automatically if the fault condition
goes away.
Manual faults require you to clear them by:
• Selecting Clear Faults/Warnings on the menu of the device that
generated the fault (if the fault condition still exists, the fault message
will reappear).
• Correcting the condition that caused the fault.
Viewing the SCP Fault Log
The fault log lists the most recent SCP faults, up to a total of 20. On each
line, the log shows the fault code, the date the fault occurred, and the time
the fault occurred.
To view the fault log:
1. On the SCP advanced menu, press the down arrow button to highlight
Fault log.
2. Press Enter.
To return to the SCP menu:
◆ Press Func.
Figure 13
SCP Fault Message
Fault: F504
System Panel
Ntewrok not available.
Check connection,
clear fault.
continue cancel
Figure 14
SCP Fault Log
Fault Log: XSCP
252 Apr/19 1:13PM
252 Apr/17 10:15AM
252 Mar/29 7:01PM
250 Mar/11 12:59AM
To Next Page
Loading...
Need help?
General
