Dear Customers,
Thank you for purchasing Xblitz GO2. The device you received
is a dashboard camera that is used to record your vehicle's route and any
trac incidents. This video recorder has the option to connect to a GPS
module and record not only videos, but also information such as its
geographic position and speed at which the vehicle is moving. Made out
of the highest quality components and materials.
Please read the user's manual before using the product.
20
01. BEFORE USE
1. It is recommended to use branded Micro SD cards (16GB to 256 GB) of speed
class 10. A list of recommended cards can be found on page www.xblitz.pl
in the GO2 tab.
2. Before inserting the card into the recorder, it should be formatted to the FAT32
file system on your computer, then in the recorder.
3. Install the memory card when the device is turned o, otherwise the card and the
device can be damaged. The same applies to removing the card.
4. Fully charged battery allows you to record without a power supply for
up to 5 minutes. The battery in the device is mainly used to maintain DVR settings.
5. When the memory card is full, the oldest unprotected recordings will
be overwritten.
6. It Is recommended to use the device features according to their intended purpose,
i.e. not using MOTION DETECTION while driving, as it can cause the device to turn
on and o automatically, e.g. when stationary at an intersection.
7. It Is recommended to set the G-SENSOR sensitivity to a minimum to avoid
protecting unnecessary materials and thus losing space on the memory card.
You must format the card in the FAT32 file system - first on a computer, and then
in the recorder.
8. Sound: The device has a capacitive microphone that records all ambient noise.
Sounds may overlap causing distortion.
To Next Page
Loading...
Need help?
General
