xDEEP NX Series User Manual

11
REPAIR AND MAINTENANCE
POST-DIVE MAINTENANCE
Disconnecting
After diving, take out the weight from the weight pockets
(if applicable), disconnect the LP hose from the inator,
and then disconnect the tank.
Draining
Inate the BC orally using the purge button of the inator.
Next turn the BC to keep the automatic dump valveat the
lowest point of the BC. Pull the valve string, at the same
time pressing the BC with your hands to make water ow
out by the open dump valve. Repeat the procedure until
all water is removed from the BC.
Rinsing
Every time you use the BC in salt or chlorinated water,
it should be rinsed thoroughly inside and out with fresh
water. Never use hot water for rinsing!
To rinse the BC inside, press the purge button of the
inator and ll the BC approximately ¼ full with water
by means of a garden hose spout or other source of fresh
water. Rotate the BC several times, and next drain it ac-
cording to the above procedure.
Drying
After every use, you should dry the BC thoroughly. When
drying, the BC should be fully inated and hung in a dry,
airy and dark place. When drying, do not expose your BC
to direct sunlight or extreme heat!
Storing
Store your BC partially inated and hung in a dry and
dark place away from sharp objects, lubricants, fuels
or solvents.
WARNING
DO NOT PRESS THE INFLATOR BUTTON WHEN
RINSING YOUR BC! THIS MAY MAKE DAMP AND
OTHER CONTAMINANTS ENTER THE INFLATOR
VALVE, WHICH MAY CAUSE SUBSEQUENT
DAMAGE TO THE VALVE.
WARNING
TO PREVENT YOUR BC FROM DAMAGE, YOU SHO-
ULD NEVER KEEP IT WET FOR A LONGER PERIOD
THAN A DOZEN OR SO HOURS.
32

xDEEP NX Series Specifications

General

Brand	xDEEP
Model	NX Series
Category	Diving Instrument
Language	English