User Guide 7
Installation
Please make sure of the following before you begin installation:
• If you are prompted to reboot during installation, please select "No". Finish installing the rest
of the software, then close all open windows and reboot your computer.
• The information in this guide may cover software not provided with the scanner you
purchased. Please disregard any information about the software not applicable to your
scanner.
• If your computer has AntiVirus or AntiSpyware software running, you may encounter alerts or
messages during installation asking you to allow the installation to proceed. Although the
messages will differ based on the software your computer is running, in each case you should
allow the installation to proceed if that option is available. Alternatively, you can turn off the
AntiVirus or AntiSpyware software before installing your scanner, but if you do, make sure to
turn it back on again when installation is finished.
• If you already have a scanner connected to your computer, it is recommended that you
remove that scanner’s driver program prior to installing your Xerox
®
scanner. You can remove
these programs from the Windows Control Panel. Please refer to the user manual provided
with your other scanner hardware for instructions about removing the driver and software for
that unit.
• If your computer is running Windows Vista or later, you may see the Windows User Account
Control screen asking you to confirm system changes. Click the Yes button to allow the
installation to proceed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
